Blue Sea M-Series Mini Dual Circuit Plus Battery Switch 300A On/Off Red

Battery management is central to safe operation

The Blue Sea M-Series Mini Dual Circuit Plus Battery Switch helps manage the overall use of electrical power on board by allowing you to connect or disconnect electrical devices from the electrical system. Use it to prevent battery drain during periods of inactivity. It also allows for a quick and easy way to shut down the entire electrical system in an emergency. The dual circuit PLUS model is designed to simultaneously switch two isolated battery banks or combines battery banks to all loads. Make before break contact design allows switching between battery banks without power interruption.

Blue Sea M-Series Mini Dual Circuit Plus Battery Switch Features:

• 300 Amps continuous rating for outboards and small gasoline or diesel engines
• Simultaneously switch two isolated battery banks or combines battery banks to all loads
• Make before break contact design allows switching between battery banks without power interruption
• Tin-plated copper studs for maximum conductivity and corrosion resistance
• Studs accept 3/8" (M10) ring terminals
• 7/8" (22mm) stud length accepts multiple cable terminals
• Blue Sea Systems one-piece terminal stud design never loosens over time
• Isolating cover with three snap-in side pieces protects rear contacts and allows wire access in any direction
• Case design allows surface, rear or front panel mounting options
• Waterproof – rated IP66 from water projected in powerful jets

Blue Sea M-Series Mini Dual Circuit Plus Battery Switch Specifications:

• Switch type: Dual Circuit Plus
• Part number: 6011
• Colour: Red
• Switch positions: 3
• Battery combine: Yes
• Alternator field disconnect: No
• Maximum voltage: 32VDC
• Stud size: 3/8"
• Terminal stud torque: 120 in-lb (13.56 Nm)
• Continuous rating: 300A
• Intermittent rating: 450A (5min)
• Cranking rating 30 sec: 675A per circuit
• Battery inputs: 2
• Cable clearance for 4/0 AWG cables: 28.45mm
• Cable size to meet ratings: 4/0 AWG (120mm²)
• Mounting holes: #10 Screw
• Stud material: Tinned copper
• Stud torque: 120 in-lb (13.56 Nm)
• Terminal stud size: 3/8" - 16 (M10)
• Weight: 0.36 kg