Enerdrive ePOWER DC2DC Battery Charger with MPPT 24v 30A

Set and forget

The Enerdrive ePOWER DC2DC Battery Charger is a fully automatic multistage, multi input battery charger with the ability to charge from either an alternator linked to a battery; or via solar power with the in built Maximum Power Point Tracking (MPPT) Solar Controller. With two inputs available, the house battery will be charged from either the engine while underway, or via the solar panels when stationary. The process to choose either engine or solar is fully automatic and both functions are controlled from within the unit itself without the need for external relays.

Multistage Charging Process
Multistage smart charging technology enables the charger to be connected to your battery banks permanently. With the input of multiple sources, you can be assured of charging your batteries whenever underway; or when the sun is shining on your solar array. Deep cycle batteries require a multistage charge sequence for perfect, fast and accurate charging.

Smart Charging
The output will be regulated based on the loads connected to your battery banks. This function is important to maintain the life of your battery banks as some battery chargers mistake loads for discharge and continue to keep the batteries in the bulk or absorption stage for extended periods of time, which will damage the battery bank. This battery charger has two methods of load based regulation to ensure your battery charger transitions to float when it should do so.

Enerdrive ePOWER DC2DC Battery Charger Features:

• Two totally independent DC Inputs for both engine and solar regulation charging one house battery bank output
• DC M6 screw terminals that will allow for large battery cable connection between all sources
• A dedicated Maximum Power Point (MPPT) solar regulator
• The same battery algorithms as included in our AC mains ePOWER battery charger including a specific lithium charging profile
• 30A output up to 40+ °C with thermo controlled fan cooling
• Fully programmable LCD display to show which source is charging the battery along with charger status, voltage and amperage
• Temperature sensor included in charger for more accurate battery charging

Enerdrive ePOWER DC2DC Battery Charger Specifications: Output Rating:

• Output Voltage: 24V Nominal (17.0V min)
• Output Current (Maximum): 30A
• Output Power: 865W

Charger DC Output (CH1):

• Selectable Battery Type: Gel, AGM, Flooded, Lithium, Program
• Charger Voltage Range: 27.6V – 31.0V
• Float Voltage Range: 26.0V – 27.6V
• Charger Current (User Selectable): 5/10/20/30A (default 30A)
• Equalise Voltage (Flooded Battery): 31.0V
• Equalise Charging Current: 10% of Bulk Current Setting
• Charging Control: 2 stage / 3 stage selectable (Default 3 stage)
• DC Output Bank: Single
• Current draw from CH1 when in use: = < 50mA
• Battery Temperature Setting: Low/ Normal/ High (Battery Temperature Sensor Standard)
• Efficiency: 95%

INPUT Rating (CH2 – MPPT Solar):

• Input Voltage: 14.5 – 45VOC
• Maximum Input: ≤ 23V input, 500W (600W allowable) ≥37.5V-45V input, 800W (1000W allowable)

INPUT Rating (CH3 – Start/Alternator):

• Input Voltage: 10.5 – 16VDC / 21 – 32VDC

Dimensions:

• Height x Width x Depth: 242 x 172 x 74mm
• Unit weight: 1.85kg
• Shipping weight: 2.17kg

Enerdrive ePOWER DC2DC Plus Battery Charger Product Brochure