J-B Weld Ultimate Grey Gasket Maker and Sealant is an RTV (Room Temperature Vulcanized) Silicone gasketing material designed for use in mechanical assemblies where higher torque or closely spaced bolt profiles can lead to higher loads and cause gasket and sealing failures for average silicones. Upon curing, which occurs when the product is exposed to the moisture in air, the silicone forms a tough, waterproof, gasket and seal on most surfaces. It will not shrink or crack, resists oil and petroleum products, resists weathering, is sensor safe, has good temperature resistance up to 500 degrees F intermittent and is great for many automotive applications.

• High-Torque Load Applications
• Oil Resistant
• Low Odour
• Sensor Safe
• Set Time: 1 Hour
• Cure Colour: Grey

• Import Vehicles
• Intake Manifolds
• Transmission Pans
• Oil Pans
• Timing Gear Covers
• Cam Covers

1. Prepare: For best results, clean and dry surface area
2. Apply: Apply even, continuous 1/4 inch bead of Silicone to one surface area. Surround all bolt holes with Silicone.
3. Assemble: Reconnect parts while Silicone is wet.
4. Secure: Hand tighten until Silicone begins to squeeze out.
5. Dry: Allow drying for 1 hour and then tighten an additional 1/2 turn.
6. Finish: Scrape or cut away excess cured sealant. Silicone will fully cure in 24 hours.