Sika MultiPrimer Marine 250ml

Improved adhesion

The Sika MultiPrimer Marine is a low viscosity liquid primer to improve adhesion of Sikaflex products on various substrates. It's used to improve the adhesion of Sikaflex adhesives on many substrates such as wood (teak, mahogany Oregon pine and cork), metals such as aluminium and galvanised steel, plastics and paint-primed substrates.

Application
Surfaces must be clean, dry and free from grease, silicones, oil and dust. Pre-treat the bond face of non-porous substrates with Sika Aktivator-205 and leave to dry. Apply a thin but covering coat of Sika MultiPrimer Marine with a brush, felt or foam applicator. It shall be applied once only. Care must be taken to ensure that this single application gives adequately dense coverage. Sika MultiPrimer Marine exhibits thermoplastic behaviour for up to 3 days following application. Ideal application and surface temperature is between 15°C and 25°C (60°F to 75°F). Consumption and method of application depend on the specific nature of the substrates and manufacturing process. Tightly re-seal container immediately after each use.

Sika MultiPrimer Marine Features:

• Excellent adhesion performance on many substrates
  
• Easy to be used and applied
  
• Excellent durability
  
• Convenient workability
  
• 250ml
  

Sika MultiPrimer Marine Specifications:

• Chemical base: Solvent-based adhesion promoter
  
• Colour: Colourless, slightly yellow
  
• Density: (CQP1 006-3 / ISO 2811-1) 1.0 kg/l approx.
  
• Viscosity: (CQP 029-3 / ISO 3219) 10 mPa·s approx.
  
• Flash point: (CQP 007-1 / ISO 13736) -4°C (25°F)
  
• Solid content: 34%
  
• Application: temperature 5 - 40°C (40 - 105°F)
  
• Application: Brush, felt or foam applicator
  
• Coverage: 50 - 150 ml/m2 approx. depending on substrate porosity
  

Note: The “Best Before Date” is, according to the manufacturer, the last date by which the product's quality is best. Product is still effective and can last for many years if properly stored in a cool, dry place.

Note: This product is suitable for experienced professional users only. Tests with actual substrates and conditions have to be performed to ensure adhesion and material compatibility.