-
Shop our Range
▼
- Deals & Promotions ►
-
Fishing
►
Featured Fishing Categories
-
Boating
►
Featured Boating Categories
-
Camping & Hiking
►
Featured Camping & Hiking Categories
-
Marine Electronics
►
Featured Marine Electronics Categories
-
RV & Motorhomes
►
Featured RV & Motorhomes Categories
-
Apparel
►
Featured Apparel Categories
-
Watersports
►
Featured Watersports Categories
-
Diving & Snorkeling
►
Featured Diving & Snorkeling Categories
-
Hunting
►
Featured Hunting Categories
-
Shop By Brand
►
-
How Can We Help You?
Give Us A Call 0800 633 257
Or get us to call you...
Note: Our shop is open Monday to Friday 8:00am to 6:00pm, Saturday 8:00am to 5:00pm and Sunday 10:00am to 4:00pm (closed public holidays).
- Fast Shipping with CourierPost 95% orders shipped same day*
- Full Warranty We'll refund, repair or replace your item*
- No Worries Returns Submit a request, receive our return label & ship it back
- Lowest Price Guarantee Find a lower price, we'll match it or we can do better!
- Massive Range 21,000+ products in stock ready to ship!
The item you're looking at is currently unavailable or has limited stock, how about this one instead?
VETUS 75709VTEB Water Separator/Fuel Filter with CE/ABYC Double 10mic
Why pay
$449.00
ONLY
$199.00
SAVE
$250.00!
- Details
- Reviews
- Questions About Product
- Details
-
Details
Fuel dip pipe
Installation instructions for Tank connection 30011 (accessory)
- You will need to make a diameter parts 25 mm (1) hole in the upper surface of the fuel tank. Choose the location of the hole so that when the boat tilts the end of the intake pipe will stay in the fuel even if the tank is not full. If the end of the intake pipe does not reach the fuel, the device will quickly choke on the air in the fuel system.
- Cut the fuel intake pipe ( diameter parts 6 mm) to the appropriate length. The end of the pipe must not touch the bottom of the tank in order to keep water and sediment from the system. It is recommended to cut the pipe short enough to leave the engine intake pipe at a lower level. This way the device cannot empty the tank.
- Install the pipe straight end first and angle the two ears below the threaded barrel inside the hole and then align the threaded barrel vertically so the ears are hooked on the underside of the tank top. Carefully slip the rubber washer over the bent pipe end and over the threaded barrel, followed by the metal washer and the nut. Thread the nut to the threaded barrel and tighten, sealing the fitting to the top surface of the tank. Silicone sealant can be added if so desired.
- Connect the fuel hose to the heater.
Products You Recently Viewed
-
Wallas Fuel Dip Pipe
ONLY $349.00Ships Apr 9 - Apr 20
