CruzPro FU-60 Fuel Gauge and Consumption Calculator

Never worry about running out of fuel again

• Display fuel remaining (in gallons, liters %), trip fuel used, total fuel used, fuel consumption rate, Time-To-Go at current consumption rate
• Trip fuel used, ideal for joint ownership boats
• Low and High fuel alarms can be set over the entire tank level range. When activated, the FU-60 built-in 85 dB alarm will sound and the display will flash. Enabled or disabled with a single key press
• The intelligence calculates the fuel usage form the tank level removing the need for an expensive flow rate sender and a subtractor unit to compensate for diesel bypass
• Can be individually calibrated to any shape tank. The calibration data is saved into a non-volatile memory which retains the information if the power is turned off
• Intelligent CruzPro gauges regulate the battery feed voltage to get highly accurate sender readings free from voltage fluctuation errors
• Works with both petrol and diesel engines
• Works with standard fuel senders: VDO, Teleflex, Faria, GM, Stewart-Warner, Centroid THREE terminal senders, Aerotech and others
• Up to five levels of back-lighting
• NMEA 0183 serial data output line or an external alarm output that can be used for fuel transfer pump control
• Operating voltage 9.5 to 33 volts
• Round bezel

• Operating Voltage: 9.5 - 33.0 VDC
• Current Drain: 0.018 amps nominal
• Accuracy: Better than 2% (trainable)
• Data Editor: Fuel level data editor. Fuel sender resistance data editor. Data editor can be used to manually enter fuel calibration data or to correct an existing calibration curve
• Display: 4 digit LCD, 5 levels of backlighting
• Displayed Data: Fuel remaining, trip fuel used, total fuel used, consumption rate (gal/liters per hr), Time-To-Go (at current consumption rate) before fuel gone
• Inputs: Works with all popular fuel senders, both American and European standards (Centroid THREE terminal senders, Faria, GM, VDO, Teleflex, Stewart-Warner, etc.)
• Manufactured to work with any standard resistance type level sender having the following resistance ranges: 0-30, 0-70, 0-90, 10-73, 10-180, 33-240, 40-250 ohms (and their reverse 30-0, 70-0, 90-0, 73-10, 180-10, 240-33, 250-40 ohms). The FU60 will actually also work with any non-standard resistive sender that varies from a minimum of 0 ohms to a maximum of 300 ohms or a maximum of 300 ohms to a minimum of 0 ohms. For example, a resistive sender that varies in resistance from 100 to 150 ohms would work. So would a sender that varies from 75 ohms to 25 ohms. The FU60 can also be ordered from the factory set to work with 4-20mA senders or 0-5V sender, as a special order item.
• External Outputs/Alarms: Output screw terminal user programmable for choice of: NMEA 0183 serial External Alarm Output Day tank fuel transfer pump control
• NMEA 0183 Data: Fuel Remaining Trip Fuel Used Total Fuel Used (Required to fill the tank) Fuel Consumption Rate Time to Go (before you run out of fuel)
• Alarms: Built-in 85 dB audible alarm. Settable Low and High fuel alarms
• Fuel Transfer Pump Control: Programmable lower fuel level limit to turn ON a fuel transfer pump. Programmable upper fuel level limit to turn OFF the fuel transfer pump
• Size: 2.5'' dia X 4.1'' deep (61mm x 104mm)
• Mounting: 2-1/8'' (55mm) round hole