CruzPro D-110 Depth Sounder

The D110 Digital DSP depth sounder uses advanced Digital Signal Processing (aDSP) to reliably display water depth from 0.4 Metres (1.2 foot) to over 365 Metres (1000+ feet).

With DSP the D110 has sensitivity not normally found in low cost depth sounders. The aDSP provides superior high speed rejection of false signals due to transducer slap (buffeting), surface turbulence, thermoclines, and double bounce. It is almost immune to other depth sounders and fishfinders operating near-by.

User programmable shallow, deep and anchor drag alarms with built-in alarm sounder and remote alarm output.

Adjustable keel offset from -6 to +6 Meters (-20.0 to +20.0 feet) to compensate for transducer location below the water line.

Depth can be displayed in feet, meters or fathoms.

The alarm values and keel offset are automatically converted if the units of measure are changed between feet, meters and fathoms.

Up to five levels of back-lighting.

All setups and calibration constants are saved to a non-volatile memory. will not be lost if power is turned off.

The D110 outputs depth and keel offset as a NMEA 0183 serial data. This information can be used to log performance or repeat the display information at a remote location.

Operating voltage 9.5 to 16 volts.

NOTE: Requires a transducer, transom and thru-hull speed/temperature transducers available separately.

• Operating Voltage: 9.50 - 16.00 VDC
• Current Drain: 0.035 amps nominal
• Operating Temperature: 32 to 122 deg F (0 to 50 C)
• Display: Large 4 digit LCD, 5 levels of backlighting with external backlight on/off control
• Display Data: Depth Shallow Alarm Deep Alarm Keel Offset Feet, Meters, Fathoms
• Ranges: 1.2 to 1000+ feet (in tenths below 20.0) 0.4 to 365+ meters (in tenths below 20.0) 0.2 to 167+ fathoms (in tenths below 20.0)
• Data Ouput: NMEA 0183 serial 4800 BAUD, $SDDPT Programmable as an external alarm output
• Alarms: Built-in 85 dB audible alarm. Settable shallow, deep and anchor drag alarms.
• Size: 4.3''' x 4.3''' (110m x 110mm)
• Mounting: 2-1/8''' (54mm) round hole