Altex Epoxy Everseal Timber Sealer Part B 1L

Reinforce and strengthen

Altex Epoxy Everseal Timber Sealer is a 2-part epoxy timber sealer and preservative, specially formulated for use on all timber surfaces including timber immersed in fresh or salt water. Epoxy Everseal provides the initial pre-treatment of timber surfaces prior to the application of a suitable coating system. It limits water penetration, particularly into the timber end grain and helps control distortion, cracking and shrinkage. For the rough and rugged waters, choose Altex Epoxy Everseal Timber Sealer.

Altex Epoxy Everseal Timber Sealer Features:

• Timber preservative
• Low viscosity
• Deep penetration into timber pores
• Excellent water resistance
• 1:1 mix ratio (by volume) allows for convenient mixing
• Recoatable with AY&B Timbercote exterior varnish or AY&B two pack undercoats and topcoats

Altex Epoxy Everseal Timber Sealer Specifications:

• Coating type: Polyamide cured epoxy
• Colour: Light amber clear
• Mix ratio: 1:1 by volume
• Gloss: Sheen at saturation
• Flash point: 27°C Setaflash
• Thinner: Altex Thinning Solvent #12
• Pot life: 8 hours at 25°C
• Induction time: 10 minutes at 25°C
• Shelf life: 12 months
• Storage: Store under cool dry conditions
• Shelf life: 48 months at 24°C (Part A) | 24 months at 24°C (Part B)
• Density: 0.93 kg per litre
• Volume solids (mixed): 31%
• Theoretical coverage rate: 12.4 sq. metres per litre at 25 microns dry (Porous surfaces will typically reduce this to half)
• Recommended film thickness per coat: 80 microns wet to obtain 25 microns dry
• Application: Spray, Brush or Roller
• Dry time (at 25°C / 50% RH):
  
  • Touch dry: 1½ hours
  • Hard dry: 3 hours
  • Minimum recoat: 2 hours with itself | 12 hours with other coatings
  • Maximum recoat: 5 days with itself and other epoxies | 36 hours with other coatings including single pack products (with light sanding)

Altex Epoxy Everseal Timber Sealer Product Data Sheet

Altex Epoxy Everseal Timber Sealer Safety Data Sheet