Newmar BI-100 12v Battery Integrator
Newmar BI-100 12v Battery Integrator
Deliver to:
Auckland 1026,
NZ
Estimated:
$5.99
2-hour Click & Collect:
(order before 3pm, in-stock products only)
Our Auckland Shop
Free
Buy now, pay later & Finance Options
Find Local Store
Report incorrect product information
Charges two separate banks without voltage drop
The Newmar BI-100 12v Battery Integrator acts as a “smart” switch to connect independent battery banks only when a charging voltage is present. Otherwise, they are isolated, and discharge between banks is prevented. This battery integrator causes no voltage drop in the charging system, while the multiple batteries are charged as a single bank whenever a charging source of approximately 13.2 VDC or 26.4 VDC or greater is present.
When the alternator or charger is off or a large load causes the voltage to drop below the disconnect point the unit breaks the common tie between the banks. This allows selective battery discharge and prevents “dumping” of a higher-charged bank into a lower-charged bank. The unit may also be remotely activated to connect other batteries through the key starter or a manual switch to provide an added “boost” from the secondary battery whenever the starter is engaged and the unit senses there is sufficient voltage in that battery to provide an assist.
Newmar BI-100 12v Battery Integrator Features:
- Enables charging of two separate banks with out voltage drop,
yet maintains 100% isolation at all other times. For systems of
three banks or more, an additional unit must be installed for each
additional bank
- Heavy duty silver-plated contactor, continuous duty rated to
100 amps or 200 amp depending on model
- Voltage sense circuit, epoxy encapsulated and heavy duty
continuous rated solenoid are all designed for use in marine
environments
- 12 volt, 100 amp model has ignition protection rating
- Easy three-wire hook up for two bank systems (BATT +, BATT +,
GROUND)
- Terminal for optional wiring of remote light indicating when
battery banks are integrated
Newmar BI-100 12v Battery Integrator Specifications:
- Operating Temperature: Control: -40 to +85˚ C, Solenoid: -28 to
+48˚ C
- Terminals: Battery Connections: 5/16" copper alloy
stud
- Dimensions (H x W x D)/Weight: 3" x 3.25" x 2.5" /
1Lb.
- Approvals: CE Marked
- Voltage: 12 VDC
- Battery Integration Point: 13.2 VDC
- Battery Disconnect Point: 12.8 VDC
- Max.Continuous Current: 100 Amps
- Peak Maximum Current: 400 Amps
Newmar BI-100 12v Battery Integrator Typical Installation
Some of our product deals are strictly limited - once they're gone, they're gone! Secure yourself this amazing deal while stocks last...by clicking the Add to Order button above.