E.Z. Steer Steering Link Kit - Outboard to Outboard Standard

Increase safety and convenience

One of the most common boating accidents is damage to the main propeller. When this happens you don't want to run the engine any longer - this could cause more damage and costly repairs. So you need to use the auxiliary engine to get everyone home safely. With the E.Z. Steer Steering Link Kit, you can safely and easily steer your auxiliary outboard engine from your boat's main wheel even if one is raised or tilted.

The E.Z. Steer ties to your kicker motor to your main motor (or sailboat rudder), allowing you to steer your auxiliary motor from the helm. It has a patented self-adjusting stainless steel rod which attaches between your main and auxiliary outboard engines. There's no need to disconnect the rod, its length will self-adjust and steer the auxiliary engine as long as you can steer your main engine.

E.Z. Steer Steering Link Kit Features:

• Model number: ST260002
  
• Suitable for connecting between two outboard motors (main and auxiliary/trolling)
  
• For engines 58cm (23") to 66cm (26") apart centre-centre
  
• For fresh and salt water use
  
• Lets you steer your auxiliary engine from your boat's main wheel
  
• No more steering while hanging over the transom with a restricted view
  
• The patented self-adjusting, stainless steel rod attaches between your boat's main and auxiliary engines
  
• Perfect for hassle-free trolling and boating
  
• Patented self-adjusting stainless steel rod attaches between your main and auxiliary outboard engines
  
• There's no need to disconnect the rod, its length will self-adjust and steer the auxiliary engine as long as you can steer your main engine even if one is raised or lowered
  
• Designed in the USA using DuPont Delrin ball joints with brass inserts for rust resistance
  
• The only self-adjusting auxiliary steering rod. Built for fresh and salt water use
  
• The Quick-connectors allow easy removal, simply push down on the Quick-connector collar to release from the Delrin ball joint, no tools are required
  
• Designed for auxiliary outboard engines up to 25hp so are perfectly matched to the range of Tenob branded Rise and Fall transom and platform mount outboard engine brackets providing a complete solution for those wanting to add a trolling or emergency outboard engine to their boat
  
• Easy to install (no drilling required)
  
• Kit includes:
  Main bracket assembly
  Small outboard bracket assembly
  All necessary hardware and self-adjusting rod
  

Assembly Instructions:

• The steering rod consists of two stainless steel tubes. To assemble, simply insert the inner grooved tube into the outer smooth tube with a twisting motion. Extend or contract the rod to the approximate length.
  
• Attach one end of the rod to the main unit bracket, pushing the quick connector’s moveable collar down, inserting the end of the ball joint into the quick connector, and re-leasing the collar. The end should now be held securely in place. Repeat for other end.
  
• Reverse the order to remove the rod. Now check for tension.
  
• The rod is preset to approximately 20# of pressure and should adjust to compensate for this position.
  
• Do not oil or grease the rod, as it will gum up the détentes and cause damage to the inner rod.
  
• For proper fit, you need to establish the year and size of the outboard, the year and size of your kicker and the distance between the two motors.